Kenwood 103AR Instruction Manual page 9

103An tEn]
emote, Qntrol unit
The remote control unit provided with the receiver can also control KENWOOD cassette decks, and CD player connected to the
receiver through system control cords. For details of the controllable functions, refer to the instruction manuals of these
components,
0
KENWOOD /
O POWER key
OBAND key -_
Press to sw=tch the broadcast band
0 P,CALL keys - _
Recalls preset stahons
O Play/pause key {1_/11) (CO)
OStop key (11) (CD)
OSkip keys (t<<, =_11 (CD)
ODISC SKIP key (CDI
For use as the disc skip key of the multi-CD player
Olnput selector keys -_
Press to select the inputs
OLEVEL MODE key -'JL
Press when adjusting the tone
@TAPE A/TAPE B keys (Cassette decks)
_Play keys (<, I_) (Cassette decks)
_Fast Forward/Rewind keys (<1_, I_1_} (Cassette decks)
_Stop key (11) (Cassette decks)
_REC/ARM key (Cassette decks)
When recording on TAPE B. puts the deck in record pause mode
after leaving a non-recorded blank of 4 seconds
MUTING key - iq'_
Press to mute sound temporarily
O LOUDNESS key -_-_..
Press to enhance low frequencies
OVOLUME/LEVEL CONTROL keys -_ -_,
Press to adjust the volume If the LEVEL MODE key _s pressed
before these keys. these keys can also be used to adiust the
tone
Model: RC-R0301
Infrared ray system
Loading batteries
Q Remove the cover.
_)|nsert batteries.
• Insert lwo AA-size (R6 / SUM 3) batteries as indicated by the
polarity marking
,'3Close the cover.
Operation procedure
When the STANDBY indicator is lit, the power turns ON when
you press the POWER key on the remote. When the power
comes ON, press the key you want to operate.
Approximate operating range
] Remote sensor
ModeI: RC R0301
Infrared ray system
• When two operat,on keys on the remote control unit are
pressed successively, press each key securely reserwng an
interval of more than 1 second for each press
I_s I The supplied batierles are intended for use if] operation checks Therefore theLr lives may be shorter than ordinary batteries
2 When the remote-controllable distance gets shorter than before, replace both batteries with new ones
3 Malfunction may occur if direct sunlight or the lighl of a high frequency lighting fluorescent lamp enters the remote control light
sensor In such a case. change the system installation pos4hon to prevent the maffunctlon