Monogram 31-46199-1 Installation Instructions Manual page 8

Installation Instructions
REVERSE THE DOOR SWING Icont.I
Reverse the hinges (all models}:
* Remove the screws opposite the door hinges,
top and bottom. Set aside.
* Remove the two screws holding top hinge.
* Turn the hinge upside down, with the hinge pin
pointing up. Reinstall the hinge on the opposite
side at the bottom of the door.
* Remove the bottom hinge. Turn the hinge upside
down and install on the opposite side at the top.
Remove the top hinge pin,
Prepare the stainless steel model door:
* Rotate the stainless steel door skin so that the
handle will be on the right side. Place the stainless
steel skin onto the door, keeping the edge
protectors in place.
* Reinstall the two screws in the top and bottom
of the door.
Reinstall the door (all m odels}:
* Place plastic hinge sleeve on the bottom hinge
and position the door onto the pin.
* Place plastic hinge sleeve in the top hinge hole
on the door. Align the door on the bottom hinge
and replace top hinge pin.
* Reinstall handle with original screws.
Top Hinge
Hinge Sleeve/
Door Stop
e Pin
Hex Head Hinge Screw
Bottom Hinge
>Hex Head
Hinge Screw
\Hinge Sleeve/
Door Stop
_"-Hinge Pin
REVERSE THE DOOR SWING Icont.}
Reinstall the door (all models) (cont.):
_- Top 4inge
J
f
Bottom Hinge
To reverse the door catch:
• Remove the plastic screws
from the opposite side
of the door.
• Remove the metal screws
from the magnetic door
catch and reinstall on the
opposite side of the door.
• Install the plastic screw
into place on the opposite
side of the door.
Reverse
Door Catch
Position
INSTALL NAMEPLATE ON STAINLESS
STEEL MODELS
• Remove paper backing from the nameplate.
• Place nameplate onto the doon