Related Manuals for Monogram ZDI15
Summary of Contents for Monogram ZDI15
-
Page 1: Installation Instructions
Installation Instructions If you have questions, call 800.626.2000 or visit our website at: www.monogram.com Automatic Icemaker ZDI15 ZDIS15 Design Guide with Installation Instructions... -
Page 2: Table Of Contents
In the absence of local codes, the icemaker should be installed in accordance with National Electrical Code ANSI/NFPA 70-1990 or latest edition. For Monogram local service in your area, call 1.800.444.1845. For Monogram Service in Canada, call 1.888.880.3030. -
Page 3: Design Information
Design Information MODELS AVAILABLE ZDI15, ZDIS15 The icemaker may be installed below a countertop or Available in black, white and stainless steel. used free-standing. CUTOUT & PRODUCT DIMENSIONS Cutout dimensions shown allow for a full door swing. Additional Clearances: • The installation of a 3/4″ thick custom panel will require an additional 1-1/2″... -
Page 4: Advance Planning
Installation Instructions ADVANCE PLANNING ADVANCE PLANNING (cont.) CAUTION: Due to excessive Before you begin: weight, TWO PEOPLE ARE REQUIRED TO 1. If a custom panel is to be installed, follow the MOVE AND INSTALL THIS ICEMAKER. instructions shown on pages 9 and 10. Failure to do so can result in back or –Order ZIP75 (black or white) panel kit. -
Page 5: Power Supply
Installation Instructions POWER SUPPLY REMOVE PACKAGING AND PARTS WARNING: • Lay the carton on rear face (Please read carefully). and break open the bottom FOR PERSONAL SAFETY, THIS APPLIANCE flap. MUST BE PROPERLY GROUNDED. Failure to • Set the carton upright follow these instructions can result in death, with all four bottom flaps fire, or electrical shock. -
Page 6: Water Supply
Installation Instructions WATER SUPPLY WATER SUPPLY (cont.) • A cold water supply is required for icemaker • Install optional water filter in the water line near the operation. The water pressure must be between icemaker. A water filter is recommended in areas 30 and 120 p.s.i. -
Page 7: Connect Water Supply
Installation Instructions CONNECT WATER SUPPLY REVERSE THE DOOR SWING • The water line should be flushed to clear any foreign IMPORTANT: Disconnect power to the material before connecting to the icemaker. icemaker. • Connect the water line to the water supply tube outside of the rear access cover. - Page 8 Installation Instructions REVERSE THE DOOR SWING REVERSE THE DOOR SWING (cont.) (cont.) Reverse the hinges: To reverse the door catch: • Using a flat putty knife, remove the screw hole plugs • Remove the plastic screws opposite the door hinges, top and bottom. Set aside. from the opposite side of the door.
-
Page 9: Before You Begin
Installation Instructions for ZIP75WW, ZIP75BB Kit BEFORE YOU BEGIN: NOTE: If installing a 3/4″ trimless custom panel, a • 1-1/2″ wide filler strip may be required. The filler strip Read these instructions completely and carefully. will act as a spacer between the icemaker case and IMPORTANT: •... - Page 10 • Tape the side trim pieces to the back of the mounting screws. Set screws aside. Discard handle. custom panel. • The Monogram nameplate is held in place with • Place the panel with trim against the door to be sure adhesive. Remove the nameplate.
- Page 11 Notes...
- Page 12 NOTE: While performing installations described in this book, safety glasses or goggles should be worn. For Monogram ® local service in your area, call 1.800.444.1845. NOTE: Product improvement is a continuing endeavor at General Electric. Therefore, materials, appearance and specifications are subject to change without notice.
Need help?
Do you have a question about the ZDI15 and is the answer not in the manual?
Questions and answers