Table of Contents
Advertisement
Step 1: Mount the nüvi
1. Clean and dry your windshield and the
suction cup with a lint-free cloth. Remove
the clear plastic from the suction cup.
Place the suction cup on the windshield.
2. Plug the vehicle power cable into the
power connector on the right side of the
cradle.
3. Snap the cradle onto the suction cup
arm.
Suction cup mount
4. Flip the lever back, toward the
windshield.
5. Fit the bottom of your nüvi into the
cradle.
6. Tilt the nüvi back until it snaps into place.
Cradle
Power cable
7. Plug the other end of the vehicle power
cable into a power outlet in your vehicle.
Your unit should turn on automatically if it
is plugged in and your vehicle is running.
Step 2: Configure the nüvi
To turn on your nüvi, slide the
key to the left. Follow the on-screen
instructions.
Step 3: Acquire Satellites
Go outdoors to an open area, out of garages,
and away from tall buildings. Stop your
vehicle, and turn on the nüvi. Acquiring
satellite signals may take a few minutes.
The
bars indicate GPS satellite
strength. When one bar is green, the nüvi
has acquired satellite signals. Now you can
select a destination and navigate to it.
Power
Advertisement
Table of Contents
