General Cleaning - Kenmore 790.9010 Series Use And Care Manual

General Cleaning
To Remove and Replace Oven Door
1. Open the door to the fully opened position.
2. Pull up the lock located on both hinge supports and engage it in the hinge levers. You may have to apply a little down-
ward pressure on the door to pull the locks fully over the hooks.
3. Grab the door by the sides, pull the bottom of the door up and toward you to disengage the hinge supports. Keep
pulling the bottom of the door toward you while turning the top of the door toward the range to completely disengage
the hinge levers.
4. To replace the door, reverse the door removal steps. Make sure the hinge supports are fully engaged before unlocking
the hinge levers.
The door is heavy. After removing door, lay it flat on the floor with its inside facing down.
To Remove and Replace Storage Drawer
To Remove the Drawer:
1.
2.
Tilt the drawer up and pull it out over the rollers.
o
Hinge Slot
• Lock engaged
/
Door removed 7_ ....
for door removal / / from range _f_
Support normal position
J L
/ Storage
F _ Drawer
Pull the empty drawer out to the roller guide stop.
I
.... Frame
To Replace the Drawer:
1.
2.
3.
Insert the rear end of the drawer into the opening.
Fit the drawer end rollers onto the guide rails.
Push the drawer in until it stops, then lift to allow the rollers to clear
the roller guide stop, and push in.
27