Kenmore 116.36922 Owner's Manual page 10

Extend the wand to its full length. Turn the
locking ring to the LOCK position. Attach the
extension wand onto the open end of the
hose.
Lower_ Suction
Wand_,,__t_Slide
t I
Align the tabs on the extension wand with
the "J" slots in the hose. Push the wand into
the hose and twist to the right to lock.
To achieve maximum reach with the attach-
ments, add the crevice tool to the end of the
wand by inserting and twisting slightly.
f:,.
Attach combination brush directly to the wand.
Brush--_
See ATTACHMENT USE TABLE for combi-
nation brush usage.
TO OPERATE SUCTION
CONTROL SLIDE
Telescopic Wand
When using attachments for cleaning
draperies, small rugs with low pile and other
delicate items, twist the suction control slide
to the open position. This slide is located on
the telescopic wand, close to the hose.
This will reduce suction for ease of cleaning.
Suction Note: Return
Control
Slide
suctioncontrol
slide to the closed
position for normal
cleaning.
CAUTION
When using attachments, be careful
not to overextend the stretch hose
when reaching. Trying to reach beyond
the hose stretch capability could cause
the vacuum cleaner to tip over.
TO STORE ATTACHMENTS
Remove the combination brush. Snap into
appropriate storage location.
Remove crevice tool from the wand by twist-
ing. Lay aside.
Remove the telescopic wand from the hose.
Twist the wand to the left and pull from the
hose end.
Unlock the wand by turning the wand locking
ring to the UNLOCK position.
Slide the lower wand into the upper wand.
Turn the wand locking ring to the LOCK
)osition.
Place the crevice tool down into the com-
pressed wand. Place the telescopic wand in
the wand holder
CAUTION
DO NOT pull the vacuum cleaner
around the room by the hose, Property
damage or personal injury could result.
10