Garmin GPSMAP 700 Owner's Manual page 15

Configuring Depth Shading
You can customize the appearance of depth shading on the Navigation chart.
NOTE: Depth shading is available with a preprogrammed BlueChart g2 Vision data card.
1. From the Home screen, select
Chart Appearance
>
2. Complete an action:
• Enter the depth. Select Done. Areas on the chart with depths shallower than the specified
value are shaded in blue, while areas with depths greater than the specified value are shaded in
white. The contour is always drawn at, or deeper than, the selected depth.
• Select Auto to use the depth from the g2 Vision chart.
Showing and Configuring Navaid Symbols
You can show and configure the appearance of navaid symbols on the Navigation chart or the
Fishing chart.
NOTE: The Fishing chart is available with a preprogrammed BlueChart g2 Vision data card.
1. From the Home screen, select Charts.
2. Complete an action:
• Select Navigation Chart
Symbols.
• Select Fishing Chart
3. Complete an action:
Navaid Size
• Select
• Select Navaid Type
• Select Navaid Type
Showing Additional Chart Details
You can show additional information on the Navigation chart.
1. From the Home screen, select
> Chart Appearance
2. Complete an action:
Land POIs
• Select
Light Sectors
• Select
show light sectors at all times, or select
out light sectors depending on the zoom level.
Chart Borders
• Select
Vision data card.
• Select Photo Points
This enables you to view aerial photos of landmarks
Showing Marine Service Points
From the Home screen, select
Service Points > On.
>
GPSMAP 700 Series Owner's Manual
®
Charts > Navigation Chart
Safety Shading.
>
> Menu > Navigation Chart Setup
> Menu > Fishing Chart Setup
to set the size of the navaid symbols shown on the map. Select a size.
> NOAA to show the NOAA navaid symbol set on the map.
> IALA to show the IALA navaid symbol set on the map.
Charts > Navigation Chart
> Symbols.
On
> to show land-based points of interest (POIs).
to show the sector in which a navigational light is visible. Select
Auto
On
> to show the area the maps cover when using a BlueChart g2
> On to show camera icons when using a BlueChart g2 Vision data card.
Charts > Navigation Chart
> Menu > Navigation Chart Setup
> Chart Appearance
> Chart Appearance.
> Menu > Navigation Chart Setup
to allow the chartplotter to automatically filter
(page 22).
> Menu > Navigation Chart Setup
Charts and 3D Chart Views
>
On
to