Figure - Daikin RXYQ72MTJU Operation Manual

NOTE
• Do not turn off power immediately after the
unit stops, but wait for at least 5 minutes.
• The system needs at least 5 minutes for the
residual operation of drain pump.
Turning the power off immediately will cause
water leak or trouble.
5-3 ADJUSTING THE AIR FLOW DIRECTION
(Refer to figure 6)
Press the air flow direction button to
1
select the air direction.
The air flow flap display swings as
shown on the right and the air flow
direction continuously varies. (Auto-
matic swing setting)
Press the air flow direction adjust button to
2
select the air direction of your choice.
The air flow flap display stops swing-
ing and the air flow direction is fixed.
(Fixed air flow direction setting)
MOVEMENT OF THE AIR FLOW FLAP
(Refer to figure 13)
For the following conditions, a micro computer con-
trols the air flow direction which may be different
from the display.
COOLING
• When operating continuously at horizontal air flow direction.
• When continuous operation with downward air flow is performed at the
time of cooling with a ceiling-suspended or a wall-mounted unit, the
microcomputer may control the flow direction, and then the remote con-
troller indication also will change.
The air flow direction can be adjusted in one of the
following ways.
• The air flow flap itself adjusts its position.
• The air flow direction can be fixed by the user.
• Automatic " " and desired position "
NOTE
• The movable limit of the flap is changeable.
Contact your Daikin dealer for details.
• Avoid operating in the horizontal direction
" ". It may cause dew or dust to settle on
the ceiling.
10
HEATING
• When starting operation.
• When the room temperature is
higher than the set temperature.
• At defrost operation.
".
5-4 PROGRAMMING START AND STOP OF
THE SYSTEM WITH TIMER
(Refer to figure 9)
• The timer is operated in the following two ways.
Programming the stop time "
tem stops operating after the set time has
elapsed.
Programming the start time "
tem starts operating after the set time has
elapsed.
• The timer can be programmed for a maxi-
mum of 72 hours.
• The start and the stop time can be simulta-
neously programmed.
Press the timer mode start/stop button several
1
times and select the mode on the display.
The display flashes.
• For setting the timer stop "
• For setting the timer start "
Press the programming time button and set
2
the time for stopping or starting the system.
Each time this button is pressed, the
time advances or goes backward by 1
hour.
Press the timer on/off button.
3
The timer setting procedure ends. The display
" " or "
lighting.
NOTE
• When setting the timer off and on at the
same time, repeat the above procedure
(from " " to "
1
• After the timer is programmed, the display
shows the remaining time.
• Press the timer on/off button once again to
cancel programming. The display vanishes.
For example: (Refer to figure 11)
When the timer is programmed to stop the sys-
tem after 3 hours and start the system after 4
hours, the system will stop after 3 hours and
start 1 hour later.
". The sys-
". The sys-
"
"
" changes from flashing to
") once again.
3