Table of Contents
Advertisement
11. Press down the cable to attach the double sided tape to the card reader board. Using the halo lines on the below picture as a guideline, do not press
beyond the suggested line or to the edge of the card reader
to prevent unnecessary bent to the flex cable.
11. Re-install back the pre-removal part in reverse order.
NOTE:
When replacing the bottom base cover, do not add unnecessary pressure at the hard drive and card reader location. This is to avoid unnecessary contact between the flex ca
edge.
Refer to the Bottom
Base Cover
replacement procedure for further information.
Back to Contents Page
- Quick Links:
- Removing and Replacing Parts
- Specifications
Hide quick links:
Advertisement
Table of Contents
