Dell XPS M1710 Service Manual page 9

Back to Contents Page
Mini-Card
Dell™ XPS™ M1710 Service Manual
CAUTION: Before you begin the following procedure, follow the safety instructions in the Product Information Guide.
CAUTION: Only products approved for use in your portable computer may be installed.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE: To prevent damage to the system board, remove the main battery (see
computer.
1. Follow the procedures in Before Working Inside Your
2. Turn the computer upside down and loosen the captive screws from the Mini-Card cover.
3. Place your finger under the cover at the indentation, and lift the cover to remove it.
4. If a Mini-Card is not already installed, go to
a. Disconnect the antenna cables from the Mini-Card.
1 antenna connectors (2)
b. Release the Mini-Card by pushing the metal securing clips toward the back of the computer until the card pops up slightly.
c. Lift the Mini-Card out of its connector.
Computer.
step 5. If you are replacing a Mini-Card, remove the existing card:
2 Mini-Card 3 Mini-Card connector
Before Working Inside Your Computer) before working inside the