8. Remove the four M2.5 x 5-mm screws (two on each side) that connect the display to the computer base.
1 display cable in cable
2 display cable pull-tab
channel
4 LED cable in cable channel 5 LED cable connector on system
1
Mini-Card antenna cables
NOTICE:
When removing the display assembly, carefully unthread the Mini-Card antenna cables through the computer base and ensure that the plastic
protectors—if present—remain on the individual cables.
9. Lift the display assembly away from the computer.
Replacing the Display Assembly
1. Thread the Mini-Card antenna cables back through the hole in the base of the computer so that they are accessible from the bottom of the computer.
board
3 M2.5 x 5-mm screws
(4)