Garmin GPSMAP 292 Owner's Manual page 47

The numbers on the top and bottom of the left side indicate the
maximum and minimum levels. The four data fields below the
chart indicate event times and levels at which the tide changes
starting in the upper-left field, going downward, then to the upper-
right, and down again. When comparing with other tide tables,
verify the depth unit value is the same for both sources. The bottom
of the chart shows the amount of time (in hours and minutes) until
the next low tide and high tide.
To select the Tide Station nearest to your location:
1. Highlight the At field, and press ENTER to open the Find
Tides Page.
2. Highlight Current Position, and press ENTER to open the
Find Near Current Position Page.
3. Select a Tide Station from the list, and press ENTER. As
you move the highlight over each Tide Station in the list, the
station is highlighted on the Map window. The distance and
bearing from your location to the highlighted Tide Station
are shown at the bottom of the list.
If you are not within this range, the message "None Found"
appears. Use the Map Position option to select a location closer to
a Tide Station.
GPSMAP 292/298 Owner's Manual
Select from a list of stations.
To select a Tide Station from a map location:
1. Highlight the At field, and press ENTER to open the Find
Tides Page.
2. Highlight Map Position, and press ENTER to open the Find
Near Current Position Page.
3. Press up or down on the ROCKER to move the map
pointer to a map location, and press ENTER. The Find Near
Other Position Page shows a list of Tide Stations near the
selected map location.
4. Select a Tide Station, and press ENTER. If the "None
Found" message appears, repeat steps 1-3 until you find a
Tide Station.
M M > T T
AIN ENU IDE AB
41