Garmin GPSMAP 2110 Installation Instructions Manual page 9

CANet Wiring for the GPSMAP 2106/2110
CANet is a high-speed sonar network. Using the CANet interface optimizes the performance of the CANet-compatible units. CANet
®
compatible unit device features, such as Ultrascroll™, are affected if a serial interface is used.
To install the 3-Wire Connector:
1. Insert up to three wires into the 3-wire connector. Do not strip the wire insulation. Refer to the following CANet Terminator Connection
diagram.
2. Use a standard pair of pliers to fully depress the red button into the connector.
3. Wipe the excess water repellent gel from the connector.
The following diagram shows CANet wiring for the GPSMAP 2106/2110.
Notes:
* Connect the drain wire only on one side.
** Fuse size varies based on the unit. See the unit's owner's manual for specific fuse information.
GPSMAP 2106/2110 & GPS 17
CANet
TERMINATOR
GREEN GREEN
WHITE WHITE
BLACK BLACK
RED
DRAIN*
ORANGE ORANGE
BLACK
3A FUSE
RED
�
�
BATTERY
10-33 VDC
CANet Wiring Diagram
CANet GREEN
EXTENSION CABLE
WHITE
ORANGE
BLACK
DRAIN*
FUSE**
1
I
NSTALLATION
CANet
TERMINATOR
GREEN
WHITE
ORANGE
BLACK
RED
I
NSTRUCTIONS
CANet
COMPATIBLE
DEVICE
7