Switching A Burner Off Automatically; Timer Starting Value - Miele KM 5773 Operating And Installation Manual

Switching a burner off
automatically
You can set a time at the end of which a
given burner will switch off
automatically. This automatic switch-off
function can be used on all of the
burners at the same time.
^ Select a power level for the zone you
require, e.g. back right, in the usual
way.
^ Touch the m sensor until the indicator
lamp for the selected zone flashes
(back right).
If more than one burner is switched on,
the indicator lamps will light up
clockwise beginning with the front left
zone.
^ Touch the - or + sensor until the time
you require appears in the display,
e.g. 15 minutes.
The time then counts down in minutes.
The time remaining can be seen in the
Timer/Memory display and changed at
any time by touching - or +.
If you want to set another burner to
switch off automatically, follow the same
steps as described above.
Timer and Memory function
If more than one switch-off time is
programmed, the shortest time
remaining will show in the display, and
the indicator lamp for that particular
burner will flash. All the other indicator
lamps will light up constantly. If you
want to check on the remaining time for
another zone, touch the m sensor until
the indicator lamp for the zone you
require flashes.

Timer starting value

The timer is set at the factory to start at
00 when the + or - sensor is touched.
This setting can be adjusted so that the
time you last used appears in the
display when you press + or - (see
"Programming - P14.").
Example:
If P14, S1 is programmed, and the last
time thetimer was used was for 5
minutes, 00 will appear in the display
when you switch on the Timer; when
you then touch + or -, the display will
change to 05.
You can still select any time you want,
even if you have adjusted the timer
default setting.
25