Garmin GHP 10 Installation Instructions Manual page 11

2.0 L or 1.2 L Pump Hydraulic Layout on SeaStar Power Assist-Enabled Boats
notes:
• Power Assist module:
◦ It may be necessary to remove the
Power Assist module to gain access to
the fittings, the hoses, and the bleed-
tee fitting.
◦ Remove the bleed-tee fitting from the
Power Assist module and relocate it to
the return port on the pump.
• 2.0 L/1.2 L pump (and motor):
◦ Install the pump to the steering lines
between the cylinder and the Power
Assist module.
Do not install the pump to the
◦
steering lines between the helm and
the Power Assist module.
◦ An unbalanced cylinder requires
an unbalanced valve on the pump
(See page 21)
◦ Mount the pump horizontally if
possible. Do not mount the pump
vertically with the pump end
(hydraulic connections) down.
• Shadow Drive:
◦ Mount the Shadow Drive horizontally
and as level as possible.
◦ Install the Shadow Drive in either
the port or the starboard hydraulic
steering line.
◦ Always install a length of hose
between the helm and the Shadow
Drive.
Do not install the Shadow Drive
◦
directly to the helm.
◦ Install the Shadow Drive between the
helm and the Power Assist module.
◦ Do not install the Shadow Drive
between the Power Assist module
and the pump.
◦ Do not install the Shadow Drive between the Power Assist module and the cylinder.
Do not turn the system on until you bleed all the air from the helm, the Shadow Drive, the pump, and all the hydraulic lines.
See page 34.
GHP 10 Marine Autopilot System Installation Instructions
Starboard line Starboard line
Return line Return line
Port line Port line
S R P S R P
Helm Helm
Bleed-tee fitting Bleed-tee fitting
(relocate to the pump) (relocate to the pump)
.0 L/1. L pump .0 L/1. L pump
(and motor) (and motor)
Notice
Shadow Drive Shadow Drive
H1 H1 H H
C1 C1 C C
Starboard fitting Starboard fitting
Port fitting Port fitting
Balanced cylinder Balanced cylinder
Sea Star Sea Star
Power Assist Power Assist
module module
11