Advertisement
KitchenAid
®
CUSTOM
PANEL FOR
TOP DRAWER
(Front Side)
23
(59.5 cm)
FIGURE 1A
MEDALLION CUTOUT DIMENSIONS
FOR TOP AND BOTTOM DRAWER
CUSTOM PANELS
1
⁄
"
7
32
(30.8 mm)
FIGURE 2
Double Drawer Dishwasher Custom Door Panel Requirements
9"
(22.9 cm)
⁄
"
7
16
1
⁄
" (32.6mm) MAX.
9
32
1
1
⁄
"
13
64
(30.6 mm)
Medallion
2
⁄
"
13
32
(60.8 mm)
IMPORTANT: It is recommended that the top and
bottom custom door panels be made from suitable
material to withstand damp conditions or adequately
sealed with a moisture-resistant material to withstand
moisture and humidity.
1) Cut the top drawer custom door panel to size as shown
(See figure 1A). The custom panels may be wider
than the dishwasher in order to match the
surrounding cabinets.
NOTE: The minimum custom panel thickness is
⁄
" (16mm). Panel thickness more than
5
8
can be accommodated but overall product depth will
increase accordingly.
2) Cut the bottom drawer custom door panel to size as
shown (See figure 1B). The custom panels may be wider
than the dishwasher in order to match the
surrounding cabinets.
NOTE: The minimum custom panel thickness is
⁄
" (16mm). Panel thickness more than
5
8
can be accommodated but overall product depth will
increase accordingly.
3) On the front sides of both the top and bottom drawer
custom door panels, measure and mark the location of
the customer supplied handle. The location is customer
preference. Do not install handles at this time.
4) On the front side of the top drawer custom door panel,
measure, mark and cut a hole for the medallion to size as
shown (See figures 1A & 2).
NOTE: The medallion must be placed within the specified
medallion area. Do not locate outside of this specified area
(See figure 1A).
5) On the front side of the bottom drawer custom door
panel, measure, mark and cut a hole for the medallion to
size as shown (See figures 1B & 2).
NOTE: The medallion must be placed within the specified
medallion area. Do not locate outside of this specified area
(See figure 1B).
6) Lay the top and bottom drawer custom door panels face
down on a protective surface to prevent damage
⁄
" (6.4 mm)
or abrasions.
4
End
⁄
" (18mm)
11
16
⁄
" (18mm)
11
16
Advertisement
