Galaxy 721.35078 Owner's Manual page 6

HOSE ASSEMBLY
After the handle has been assembled, attach the
lower hose holder (see below). Insert the upper
hose end into the opening on the upright back.
Place the hose over the hose holder. Clip the
hose into the lower hose holder. Slide and twist
the lower hose end into the hose coupling on the
floor nozzle. Make sure hose is firmly connected
before using the vacuum.
Handle
Holder
Hose
Holder
Upper
Hose
End
Coupling
CORD ASSEMBLY
Make sure the quick release cord hanger is in
the upright position. _,,
Lock the cord into
place by forcing it Notch
into the locking \ .....
notch on the body
of the upper cord
hanger as shown.
This helps keep the
power cord out of Cord
the path of the floor
nozzle.
Release Cord
Ranger
Cord
Cord
Ranger
Wrap the
power cord
around the
quick release
cord hanger
and lower cord
hanger, and
clip the plug
onto the power
cord.
OPERATING INSTRUCTIONS
1, Turn the quick
release cord hanger
to either side and
down to release the
power cord.
Quick
Release
Cord
Hanger
2, Unclip the power cord plug from the power
cord and pull the cord off the quick release cord
hanger. Check to be sure the power cord is still
locked into the locking notch. See CORD
ASSEMBLY.
3, Check to see if the cleaner has bag
installed. See DUST BAG CHANGING.
4, Plug the polarized power cord into a 120
Volt electrical outlet.
-6-
NOTE: To reducethe risk of electricshock, this
vacuum cleanerhas a polarizedplug, one blade is
wider than the other. This plug will fit in a polarized
outlet only one way. If the plug does not fit fully in
the outlet, reversethe plug. If it still does not fit,
contact a qualified electricianto installthe proper
outlet. Do not change the plug in any way.
WARNING
Personal Injury and Product Damage
Hazard!
• DO NOTplug in if switchis in ON position,
Personalinjuryor product damagecould
result,
• DO NOTuse outletsabovecounters,Damage
to itemsin surrounding areacouldoccur.