Lubricating The Drive Chain - Yamaha Blaster YFS200T Owner's Manual

q
w
1. Locknut 2. Chain adjuster
3. After adjusting, be sure to tighten the lock-
nuts and the wheel hub bolts.
Upper wheel hub bolt:
50 Nm (5.0 m0kgf, 36 ft0lbf)
Lower wheel hub bolt:
50 Nm (5.0 m0kgf, 36 ft0lbf)
e
q
w
3. Alignment marks
EBU00805

Lubricating the drive chain

The drive chain must be cleaned and lubricated
at the intervals specified in the periodic mainte-
nance and lubrication chart, otherwise it will
quickly wear out, especially when riding in dusty
or wet areas. Service the drive chain as follows.
cC
The drive chain must be lubricated after
washing the ATV or riding in the rain.
1. Clean the drive chain with kerosene and a
small soft brush.
8-33