Rdc2 Controller Menus; Main Menu - Kohler 14/20RESA Operation

3.7 RDC2 Controller Menus

Controller menus display power system information,
including status information for the engine, generator,
and optional RBUS accessories, exercise settings, and
event history. Some menus allow changes to the
controller settings.
Diagrams in the following sections show how to navigate
through the menus.
Note: Use caution when navigating the controller
menus. In some menus, pressing the Select
button can enable editing of the controller
settings. Changing the settings to incorrect
values can adversely affect generator set
operation or render the unit inoperable.
If a setting on the controller display is flashing, edit mode
has been enabled. Press the OFF or AUTO button to
exit the edit mode.
Status
Displays
Press the Up and Down arrow buttons
to move between menus.
Press OFF or AUTO to exit the menus.
* ATS configuration appears only if a Model RXT transfer switch is connected.
Figure 3-9 RDC2 Main Menu
36 Section 3 RDC2 Controller Operation

3.8 Main Menu

Press the Select button once to bring up the main menu.
Overview is displayed. See Figure 3-9. Press the down
arrow button to step to the next menu, Engine Metering.
Use the UP and DOWN arrow buttons to step up and
down through the menus shown in Figure 3-9.
The controller will exit the main menu after 5 minutes if
no buttons are pressed.
immediately, press the controller's OFF or AUTO
button.
Overview ---->
1.2 h
Engine ---->
Metering
Generator---->
Metering
Genset ---->
Information
Genset ---->
Run Time
Genset ---->
System
ATS ---->
Status
To exit the main menu
ATS ---->
Configuration *
Date ---->
and Time
Network ---->
Information
PIM ---->
Status
Load ---->
Control
Event Log---->
TP-6804 12/11
tp6804