Table of Contents
Advertisement
Available languages
Available languages
Installation
Instructions
[]
LEVEL THE WASHER OR DRYER
[]
Locate the 4 legs from the parts package
and install.
[]
Stand the washer or druer upright,
love
it
close to its final location.
[]
Make sure that the washer or dryer is level
bu placing a spirit level on top. Check side
to side and front to back.
[]
Use an open
ended wrench to
adjust the legs
in and out.
Tighten the lock
nut against the
bottom
of
the pedestal.
NOTE:
• To minimize
vibration,
the locking
nuts must
be tight.
• To reduce vibration,
ensure that all four rubber
leveling
legs are firmlg
touching
the floor. Push
and pull on the back right and then the back
left of gour washer
or drger.
[]
REMOVE
SHIPPING
SCREWS
Removethe 4 shipping screws on the back side
of the unit.
[]
FINALIZE THE INSTALLATION
Refer to the washer or druer Installation Instructions
to complete the installation.
[]
REINSTALL THE DRAWER
[]
Check to
be sure the
slides are
closed.
[]
Slide the
drawer
into the
Drawer
,o
/
opening.
Align the
J
drawer
supports
to the
slides on each
side.
[]
Reinstall the original screws into each drawer
slide. Tighten both screws.
[]
Open the drawer fullu. Slide drawer divider
into slots in the center of the drawer. The
drawer should slide smoothlu
when Uou push
it closed.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT
NOTICE
3
Advertisement
Table of Contents
