Table of Contents
Advertisement
Available languages
Available languages
Installation
Instructions
[]
PREPARE
THE
PEDESTAL
[]
Pull the
drawer out
as far as it
will go.
]
Remove screws
from drawer
slides. Slide
drawer out of
the base and
set aside.
\
FOR DRYERS ONLY:
[]
Locate the 4 support pads from the parts
package. Each pad has 2 protrusions
that fit
into the holes on top of the pedestal. Press
the rubber pads into each set of corner holes
on the top of the pedestal as shown.
ii
@
NOTE: The support
pads should be installed
on
the dryer
onlg. DO NOT INSTALL THESE PADS ON
THE WASHER PEDESTAL.
[]
[]
[]
INSTALL THE PEDESTAL
TO THE WASHER OR DRYER
Place the pedestal against the bottom
of the unit. Check to be sure the drawer front
is at the front of the unit.
Align the holes in the pedestal with the
holes in the bottom of the unit. Use a Phillips
screwdriver
to install the 4 screws through
the
pedestal and into the unit-do
not tighten.
[]
Slide the pedestal toward the unit, until it is
aligned front to back. Use an 8 mm socket
wrench to securelu tighten the screws.
2
Advertisement
Table of Contents
