GE DNCD450 Installation Manual page 2

Applying the Braille Overlay
1. Plug the washer or dryer back in.
2. For washers: Using the old overlay as a reference,
press and hold the White Cottons button in the
upper left corner and the Startbutton in the upper
right corner of the control panel. After 3 seconds,
all lights on the control panel will light up.
For dryers: Using the old overlay as a reference,
press and hold the AirOrybutton in the lower left
and the High heat button in the upper right of the
control panel. After 3 seconds, all lights on the
control panel will light up.
3. Peel the paper backing from the Braille overlay.
Starting on one side of the panel, apply the Braille
overlay over the buttons, using the lights for
alignment. If the overlay does not line up properly
so all lights are visible through the overlay, peel it
off and reapply. Once the overlay is properly
aligned, press firmly around the border to secure
it in place.
4. Once the overlay is applied, press STOP/CANCEL
to turn off the control panel lights.