Advertisement
03-242.Sanyo.85464359404000
• For surface mounting on the wall, see Fig. 2.
1. Insert a screwdriver or the like in the groove on the
lower side of the remote controller to pry off the
back case. (See Fig. 3)
2. Use the 2 supplied M4
embeded mounting or M4
surface mounting to secure the remote controller
back case. Prior to mounting, clear the cutouts in
the back case corresponding to the holes in the
wall box using a screwdriver or the like. Use the
spacers and take care not to tighten the screws
excessively. If the back case will not seat properly,
cut the spacers to a suitable thickness.
3. Connect locally supplied 3-core lead wires to the
lead wires from the remote controller. (See "How to
wire the remote controller.")
(The remote controller will be damaged if
220/240V AC is applied.)
4. Hook the remote controller to the tabs of the back
case and mount it.
How to wire the remote controller
Connection diagram
See Fig. 4.
6 supplied
Lead wire from
white wire
indoor unit
joints
Lead wire
from
remote controller Wire
How to connect the harness (supplied parts)
1. Turn off the power, and remove the grille.
2. Remove the screws of the electrical box and
remove its cover.
3. Pull out the indoor unit controller (PCB ass'y).
(Fig. 6 on next page)
4. Pull out the lead wire that connects the remote con-
trol receiver to CN11 of the controller (PCB ass'y).
(Fig. 5 on next page)
5. Plug the socket of the supplied wire harness onto
CN11.
6. Bind the wire harness and the inter-unit lead wires
together, and route them. Fasten them under the
electrical box with the clamp. Then, pull them out
from the back of the indoor unit.
If required, connect the lead wire (field supply, max.
10 m). (Fig.4)
Use the supplied wire joints (6 pcs.) to connect the
lead wire. (See the connection diagram as shown at
right.)
8/21/03
9:17 AM
Page 2
25 machine screws for
25 tapping screws for
1. Peel off 14mm of cable
sheathing on each wire.
2. Twist the 2 wires
together and crimp them
together with a wire joint.
3. When a crimping tool is
not used, solder the
joint
wires together and cover
the joint with insulating
tape.
Under-case (back case)
Remote controller
Lead
wires (3)
Tapping screws
M4
25 (2)
Wire joint
RED
WHT
BLK
Indoor
unit
Wiring from
indoor unit
*1
Wiring for remote
controller (supplied locally), Max. 10m
2
2
*1: 0.5mm
to 2.0mm
wires are used for lead wires.
2
Wall
Fig. 2
Fig. 3
Approx. 200mm
RED
1
Remote
WHT
2
Controller
BLK
3
Wiring from
remote controller
Wire joint
Fig. 4
Advertisement
