For Manual Start; For Electric Start - Central Pneumatic 30 Gallon, 180 PSI Gas Powered Two-Stage Air Compressor Manual

5. To start a cold engine, move the Choke to the CHOKE (start/
closed) position.
To restart a warm engine, leave the Choke in the
RUN position.

For MANUAL START

6.
A. Turn the Engine Switch to ON.
ON
OFF START
b. Grip the Starter Handle of the Engine loosely and pull it
slowly several times to allow the gasoline to flow into the
Engine's carburetor. Then pull the Starter Handle gently until
resistance is felt. Allow Cable to retract fully and then pull it
quickly. Repeat until the engine starts. Note: Do not let the
Starter Handle snap back against the engine. Hold it as it
recoils so it doesn't hit the engine.
7. Allow the Engine to run for several seconds. Then, if the
Choke lever is in the CHOKE position, move the Choke
Lever very slowly to its RUN position.
Note: Moving the Choke Lever too fast could kill the engine.
8. Close the Pilot Valve by rotating it to a horizontal position.
Item 67853
ON
For technical questions, please call 1-800-444 3353.
5

For ELECTRIC START

Turn the Engine Switch to START.
Note: To prolong starter life, use short starting cycles
(5 seconds maximum). Then wait one minute before
attempting to start again.
ON
OFF START
7
8
START
Page 9