Adjusting The Control Cable - Toro 38282 Operator's Manual

Hide thumbs Also See for 38282:

Operator's manual (21 pages)

Table Of Contents

Table of Contents

1. Move the machine to a level surface.

2. Clean around the oil fill cap (Figure 11).

3. Unscrew the oil fill cap and remove it.

4. Slowly pour oil into the oil fill hole. Wait 3 minutes,

then check the oil level on the dipstick by wiping the

dipstick clean and then inserting, but not screwing

in, the oil fill cap into the hole.

Note: To determine the proper oil level on the

dipstick, refer to Figure 7.

1. The oil level is at its

maximum.

2. The oil level is too

high—remove oil from

the crankcase.

Note: Fill the engine crankcase with oil until the

dipstick indicates that the engine oil level is correct

as shown in Figure 7. If you overfill the engine with

Figure 6

Figure 7

3. The oil level is too

low—add oil to the

crankcase.

oil, remove the excess oil as directed in Changing

the Engine Oil.

Note: You may tip the machine forward (handle

up) a little to make adding oil easier. Remember to

return the machine to the operating position before

checking the oil level.

Important: Do not tip the machine all the way

forward onto its nose, or fuel may leak out of

the machine.

5. Screw the oil fill cap into the oil fill hole and hand

tighten it securely.