Hitachi HUS157336EL3600 Oem Manual page 14

Note 9. Recoverable error is measured at the nominal condition with voltage,
temperature and default error recovery parameters.
Note 10. The drive should be mounted properly (see section 8).
Note 11. MTBF represents a prediction of performance based upon a large
statistical sample calculated in accordance with Hitachi's standard
procedures.
Hitachi does not warrant that the predicted MTBF is representative of any
particular unit or group of units comprising a customer base. The actual
failure rates will vary from unit to unit. Surface temperature of HDA is
50°C or less.
A failure defined by MTBF calculation is any event that requires repair or
replacement of HDD.
Note 12. Total idle mode power (W) / Total formatted capacity (GB)
Note 13. When the Ultrastar 15K73-73 is formatted to 512 Bytes/sector,
the maximum Logical Block Address is (89B88FF)h.
When the Ultrastar 15K73-36 is formatted to 512 Bytes/sector,
the maximum Logical Block Address is (44DC47F)h.
Note 14. Power measurement values in operating (Random Seek/ Read/ Write) case are
shown in Table 4.3.
30 IOs per second
60 IOs per second
90 IOs per second
(Measurement conditions:Random Read/Write,Block Length=8,Cache=off)
Table 3.3 Power measurement (Operating)
Ultrastar 15K73-73
13.2
14.5
16.0
Drawing No. Sheet No. Revision 5
K6602906
Unit:(W)
Ultrastar 15K73-36
10.9
12.1
13.6
14/46 2003/6/12