Table of Contents
Advertisement
Installation of the WinTV-DVB / NEXUS card
After you have prepared your computer, you can begin with the installation of
the WinTV-DVB / NEXUS card.
1. Make sure that Windows 98, Me or 2000 is installed correctly, before you
insert the WinTV-DVB / NEXUS card.
2. Shut down Windows and switch off the computer.
3. Remove the housing cover of the P .C. If necessary, check in your compu-
ter manual, as you must remove the housing cover.
4. Select a free bus-master PCI card slot. In most computers all PCI slots are
bus master enabled.
5. If necessary, remove the backplate of the selected empty PCI slot location.
6. Insert the WinTV-DVB / NEXUS card into the PCI slot location and press
firmly down until the card is fully inserted and sits correctly.
7. Fasten the card with the retaining screw and replace the housing cover of
the computer.
8. Connect your satellite reception antenna with the upper (outside) or single
connection of the WinTV-DVB / NEXUS card.
Now you can install card for driver and application software for the WinTV-DVB
/ NEXUS.
Installation of the WinTV-DVB / NEXUS Driver
1. Make sure that the WinTV-DVB / NEXUS card is inserted into your com-
puter as described in the previous section.
2. Switch the computer on.
3. When Windows starts, it will detect the new hardware automatically and
requests you to install the driver files. Insert the WinTV-DVB / NEXUS CD-
ROM into your CD-ROM Drive (where x is the driver letter of the CD-ROM
drive) and select the Saa714n.inf. Follow the on-screen instructions to
WinTV-DVB / NEXUS Installation and Reference Manual
7
Hide quick links:
Advertisement
Table of Contents
