Using The Printer's Features; Tear Feature; Forms Tear-Off Feature - Oki ML3310e Help Manual

Skip Over Perforation. Change to Yes if you want the
printer to go to the next page when it comes within 1" (25
mm) of the bottom of the page. Keep it set to No if your
software has its own page formatting controls.
Slashed Letter O. If set to Yes, capital and lower case
slashed O (Ø and ø) will appear at locations 9Bh and 9Dh
respectively in USA code page. If set to No, the characters
"¢" and "¥" will appear at these locations.
Style. Change to italics if you want the printed characters
to be slanted.
Time Out Print. If your software spends a long time
processing between portions of data it feeds to the printer,
change the setting to Invalid to keep your printer from
inadvertently dumping the received data while it is waiting
for more.
Wait Time. Sets the amount of time the printer will wait
for more data before moving to the form tear-off position.
Zero Character. If you do not want the printer to use a
slash to distinguish the number zero from the capital letter
O, change the setting to Unslashed.
Help Guide

Using the Printer's Features

Tear Feature

Use this feature to advance continuous-form paper up to the
tear position by simply pressing TEAR ( ).
SEL
SEL
MENU SHIFT
EXIT GROUP
POWER ALARM
Note: The Tear Feature can not be used when the op-
tional pull tractor is engaged.

Forms Tear-Off Feature

Important! Never engage Forms Tear-Off when printing
on labels!
The Forms Tear-Off feature automatically moves
continuous-form paper up to the tear position after the
interval you select, then moves it back down again for
printing when the printer receives more data.
LF FF/LOAD TEAR PARK QUIET
Micro Feed Micro Feed
TOF
Down
Up
PRINT
ITEM SET
MENU
21