Table of Contents
Advertisement
You can set two different kinds of behavior for the warning: one is applied up to a
certain speed limit and the other one is used above that.
5.1.4.1
Speeding tolerance
The NVX225 Navigator will warn you when you exceed the speed limit by the amount
specified here. Select whether you want to specify the tolerance as a fixed value
(offset to the speed limit) or as a Percentage.
The slider will change depending on which mode you have chosen.
Both positive and negative values can be given in either offset or percentage mode.
5.1.4.2
Alternative speed limit
If the speed limit of the current road segment equals or is above this limit, the speed
warning will use the alternative tolerance instead of the previous one.
Move the slider to its rightmost position to turn off the alternative speed warning.
Then the settings of the upper slider will determine the warning for all roads.
5.1.4.3
Alternative speeding tolerance
If the speed limit of the current road reaches the value set at Alternative speed limit,
this setting will replace the basic one set at the top of this screen. The slider and the
selector work exactly as the basic ones described in 5.1.4.1.
Example: to let you better understand how this feature works, here is an example. If
you use the setting on the left (portrait) screen example (+10 km/h – 100 km/h –
+5%), The NVX225 Navigator will warn you when driving at the following speeds:
Speed limit
40 km/h
60 km/h
90 km/h
100 km/h
120 km/h
160 km/h
58
Warning at
50 km/h
(=40 km/h + 10 km/h)
70 km/h
(=60 km/h + 10 km/h)
100 km/h
(=90 km/h + 10 km/h)
105 km/h
(=100 km/h + 5%)
126 km/h
(=120 km/h + 5%)
168 km/h
(=160 km/h + 5%)
Advertisement
Table of Contents
