Fcc Compliance; Map Data Information - Garmin fleet 590 Product Information

• Only replace the battery with the correct replacement
battery. Using another battery presents a risk of fire or
explosion. To purchase a replacement battery, see your
Garmin dealer or the Garmin Web site.
Additional Non-User-Replaceable Battery Warning:
• Do not remove or attempt to remove the non-user-
replaceable battery.
Windshield Mounting Legal restrictions
Before using the suction cup mount on your windshield,
check the state and local laws and ordinances where you
drive. Some state laws prohibit drivers from using suction
mounts on their windshields while operating motor vehicles.
Other state laws allow the suction mount to be located only
in specific locations on the windshield. Many other states
have enacted restrictions against placing objects on the
windshield in locations that obstruct the driver's vision.
It Is the UseR's RespoNsIBIlIty to moUNt
the GARmIN DevIce IN complIANce WIth
All ApplIcABle lAWs AND oRDINANces. Where
required, other Garmin dashboard or friction mount options
should be used. Always mount your Garmin device in a
location that does not obstruct the driver's view of the road.
Garmin does not assume any responsibility for any fines,
penalties, or damages that may be incurred as a result of any
state or local law or ordinance relating to the use of your
Garmin device.

Map Data Information

Garmin uses a combination of governmental and private data
sources. Virtually all data sources contain some inaccurate or
incomplete data. In some countries, complete and accurate
map information is either not available or is prohibitively
expensive.
radio Frequency Exposure
This device is a mobile transmitter and receiver that uses its
antenna to send and receive low levels of radio frequency
Notice
(RF) energy for data communications. The device emits
RF energy below the published limits when operating in
its maximum output power mode and when used with
Garmin authorized accessories. To comply with FCC and
Industry Canada RF exposure compliance requirements,
the device should be used in its automobile mount or as a
handheld device only. The device should not be used in other
configurations.
This device has been shown to be compliant with FCC RF
exposure requirements for a minimum distance of 10mm
between the device and the body and zero distance for hand
operation.
This device must not be co-located or operated in conjunction
with any other transmitter or antenna.
For actual SAR values, go to
/compliance.

FCC Compliance

This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15
of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses,
and can radiate radio frequency energy and may cause
harmful interference to radio communications if not installed
and used in accordance with the instructions. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the
following measures:
• Reorient or relocate the receiving antenna.
http://www.garmin.com