Pioneer DEH-X7600HD Owner's Manual page 26

Section
04 Installation
Removing the unit
1 Remove the trim ring.
1 Trim ring
2 Notched tab
! Releasing the front panel allows easier ac-
cess to the trim ring.
! When reattaching the trim ring, point the
side with the notched tab down.
2 Insert the supplied extraction keys into
both sides of the unit until they click into
place.
3 Pull the unit out of the dashboard.
Removing and re-attaching the
front panel
You can remove the front panel to protect your
unit from theft.
For details, refer to Attaching the front panel on
page 5.
Fastening the front panel
Only for DEH-X9600BHS
If you do not plan to detach the front panel, the
front panel can be fastened with supplied
screws and holders.
26
En
1 Attach the holders to both sides of the
front panel.
1 Holder
2 Replace the front panel to the unit.
3 Flip the holders into upright positions.
4 Fix the front panel to the unit using fix-
ing screws.
1 Screw
Installation
Securing the front panel
Only for DEH-X8600BH, DEH-X7600HD, DEH-
X8600BS and DEH-X7600S
The front panel can be secured with the sup-
plied screw.
1
1 Screw
Installing the microphone
Only for DEH-X9600BHS, DEH-X8600BH and DEH-
X8600BS
CAUTION
It is extremely dangerous to allow the micro-
phone lead to become wound around the steer-
ing column or shift lever. Be sure to install the
unit in such a way that it will not obstruct driv-
ing.
Notes
! Install the microphone in a position and ori-
entation that will enable it to pick up the
voice of the person operating the system.
! Use separately sold clamps to secure the
lead where necessary inside the vehicle.
When installing the microphone
on the sun visor
1 Fit the microphone lead into the groove.
1
2
1 Microphone lead
2 Groove
2 Install the microphone clip on the sun
visor.
With the sun visor up, install the microphone
clip. (Lowering the sun visor reduces the voice
recognition rate.)
1
1 Microphone clip
When installing the microphone
on the steering column
1 Detach the microphone base from the mi-
crophone clip.
To detach the microphone base from the micro-
phone clip, slide the microphone base.