Table of Contents
Advertisement
FIRE HAZARD
A clothes dryer produces combustible lint. The
dryer must be connected to an outdoors exhaust.
Regularly inspect the outdoor exhaust opening
and remove any accumulation of lint around the
open !ng a
he surround!ng area: ..............................................................................................
Clean the lint filter after every load.
To reduce risk of fire or serious injury to persons or property,
comply with the basic warnings listed in the Tmportant
Sa
[nstruct !o n
those I!st
ow: ......................................................
*
Before cleaning the dryer interior, unplug the electrical
power cord to avoid electrical shock hazards.
.
Do not use any type spray cleanser when cleaning the dryer
interior, Hazardous fumes or electrical shock could occur,
INSIDE
*
Clean the lint filter after every load. Lint build-up on the
filter restricts air flow, which causes longer drying times.
The filter is located at the bottom of the door opening. Re-
move by pulling straight up. Remove the lint and replace
the filter.
*
Occasionally a waxy build-up may form on the lint filter
and/or moisture sensing bars from using dryer-added
fabric softener sheets. To remove this build-up, wash them
with warm, soapy water. Dry the filter thoroughly and
replace. Do not operate the dryer without the lint filter in
place.
*
:If the dryer drum becomes stained from noncolorfast
fabrics, clean the drum with a damp cloth and a mild liquid
household cleanser. Remove cleanser residue before dry-
ing the next load.
,
Every 18 months an authorized servicer should clean the dry-
er cabinet interior and exhaust duct. These areas can collect
lint and dust over time. An excessive amount of lint build-up
could result in inefficient drying and possible fire hazard.
OUTSIDE
*
Clean the cabinet with mild soap and water. Never use
harsh, gritty or abrasive cleansers.
*
If the cabinet becomes stained, clean with diluted chlo-
rine bleach (1 part bleach to 8 parts water). Rinse several
times with clear water.
*
Remove glue residue from tape or labels with a mixture of
warm water and mild detergent. Or, touch residue with the
sticky side of the tape or label.
*
Before moving the dryer, place a strip of cardboard or thin
fiberboard under the front leveling legs to prevent damage
to the floor.
Do not store or place laundry products on top of
dryer at any time. They can damage the finish or
controls.
Advertisement
Table of Contents
