Before Operating Your Dryer
Read your dryer Owner's Guide. It has important safety and
warranty information. It also has many suggestions for best dry-
ing results.
To reduce the risk of fire, electric shock or
injury to persons, read the IMPORTANT SAFETY INSTRUCTIONS
in your dryer Owner's Guide before operating this appliance.
Operating Steps
Read "Drying Procedures" in your Owner's Guide. It explains
these operating steps in detail.
1. Prepare items for drying.
2. Check that lint filter is clean and in place.
3. Load the dryer. If desired, add a dryer fabric softener sheet.
Close the door.
4. Select the appropriate cycle and settings for each load.
• Turn the Cycle Selector knob to select the cycle.The
estimated drying time will be displayed.
• Suitable drying temperature, dryness level and options will
automatically be indicated for each cycle. To change the
temperature and dryness level, press TEMP and
DRYNESS until the desired selections are made.
• To select an option, press OPTIONS until the
indicator for a desired option flashes and press
Select. Follow the same steps to delete an option.
• If a dryness level or option is not available for a cycle, it will
not light.
• Changes made to the cycle will automatically be
remembered the next time that cycle is selected.
• See the "Dryer Settings Chart" for more details.
5. Press START to begin the cycle.
• To pause the cycle or change settings, press Pause/Cancel
once. "PAU" will be displayed alternately with the estimated
drying time. To resume the cycle, press START.
• To stop or change the cycle, press Pause/Cancel twice.
6. A signal will sound at the end of the cycle and periodically
during Press Saver when the Cycle Signal option is selected.
When the cycle ends, remove items immediately and hang or
fold.
7. Clean the lint filter after every load. The Clean Lint Filter
indicator will light at the end of the cycle as a reminder.
Cycle Selection
Turn the Cycle Selector knob to the desired cycle. For best
results, follow the fabric care label instructions on items to be
dried. To change the selection after the cycle has begun, press
Pause/Cancel twice, select a new cycle and press START. Just
turning the knob to another selection will not change the cycle.
DRYER OPERATING INSTRUCTIONS
The signal will beep and the status lights will flash, but the original
cycle will continue.
Auto Dry
Auto Dry cycles take the guesswork out of drying time. Loads
dried using the Towels, Normal, Perm Press and Delicate cycles
will dry automatically at the selected temperature to the desired
dryness level. The dryer uses sensing bars to sense the moisture
level of the load as it tumbles through heated air. Auto Dry cycles
save time and energy and protects fabrics. The estimated drying
time will be displayed for about 5 minutes. Then the outside of
the display will light up in a circular track to indicate the drying
time is automatically being determined by the sensors. When
the load has reached the selected dryness level, it will continue
to tumble, unheated, during a Cool Down period. This helps
reduce wrinkling and makes items easier to handle during
unloading. The estimated Cool Down time will be displayed.
Drying time varies depending on size and dampness of load and
fabric type. If the load is too small or almost dry, the sensing
bars may not detect enough moisture to continue the cycle and
the cycle may end after a few minutes. Select a Timed Dry
setting to dry such loads.
Room temperature and humidity, type of installation and electrical
voltage or gas pressure can also affect drying time.
Towels
Select this Auto Dry cycle for towel loads.
Normal
Select this Auto Dry cycle for cotton items.
Perm Press
Select this Auto Dry cycle for cottons and blends with a no-iron
finish.
Delicate
Select this Auto Dry cycle for knits and delicate items.
Quick
Select this cycle to quickly dry a small load made up of just a
few items. It provides approximately 20 minutes of tumbling
followed by a 10-minute cool down period.
Bulky
Select this cycle to dry a comforter, blanket, sleeping bag or
similar item.Cool Down is approximately 10 minutes.
Timed Dry
To manually select the drying time for any load, turn the knob to
a numbered setting. Drying times from 15 to 90 minutes are
available in 15-minute increments. You will not be able to select
a cycle or dryness level. Timed Dry is recommended when using
the No Heat option.
Note: To change cycles, press Pause/Cancel twice.
To avoid fire hazard, do not use heat to dry items
containing feathers or down, foam rubber, plastic, or similarly
textured, rubber-like materials. Use the No Heat setting only.
137102600 (0806)