Advertisement
P P L L O O T T T T E E R R O O P P E E R R A A T T I I O O N N
S S E E L L E E C C T T I I N N G G T T H H E E P P L L O O T T T T E E R R D D I I S S P P L L A A Y Y
1. Press the [PLTR] MODE key to turn the
Plotter on
2. Press the [PLTR] MODE key again if you want
to turn the Plotter display off.
S S E E L L E E C C T T I I N N G G T T H H E E R R A A N N G G E E
1. Press the ZOOM [IN] key to decrease the
Plotter range scale and the ZOOM [OUT] key
to increase the Plotter range scale.
M M A A N N O O V V E E R R B B O O A A R R D D
1. Press and hold the [MOB] key until confirmation
appears to enable the MOB mode. The MOB
position will appear as a large "M" waypoint.
S S T T O O R R E E A A N N E E V V E E N N T T
1. Press the [MOB] key momentarily to save the
current ship position as an event. These events
are saved to memory and can be returned to
via the GOTO L/L position method.
E E N N T T E E R R I I N N G G M M A A R R K K S S
1. Use the cursor [LM] keys to move to your
desired mark coordinates
2. Press the [MARK] key to place a mark at the
cursor position. To place a mark at current ships
position, turn off the cursor by pressing the +/-
key. (See page 3-7 in op. manual to change
mark color and shape.)
R R E E G G I I S S T T E E R R I I N N G G W W A A Y Y P P O O I I N N T T S S
1. Press the [WPT] key to access the waypoint
menu
2. When menu appears, you may enter waypoints
by using the cursor, saved event, own ships
position or via direct entry on the waypoint list.
(See page 3-9 in the op. manual)
Increases and
decreases the chart
range scale.
Creates Man Over
Board Mark.
Activates mark menu
allowing you to
assign a mark.
Activates goto menu
allowing you set a
course.
Activates waypoint
menu allowing you to
create a waypoint.
Confirms entry.
Moves Plotter
cursor in direction
arrow is indicating.
Escapes the Plotter
menu and brings
you back to the
display mode.
Toggles the Plotter
display on and off.
S S E E T T T T I I N N G G / / C C A A N N C C E E L L I I N N G G D D E E S S T T I I N N A A T T I I O O N N
1. Press the [GOTO] key to set your destination
waypoint by cursor, event, L/L position,
waypoint number or route number
2. Current destination waypoint may also be
cancelled in this menu.
Advertisement
