Advertisement
Available languages
Available languages
INSTALLATION INSTRUCTIONS
Gather the required tools and parts before starting installation.
Tools needed
•
Tape measure
•
Pliers
•
Phillips screwdriver
•
Metal snips
•
Hand or electric drill
•
Caulking gun with
•
Duct tape
weatherproof
caulking
Parts needed
•
A UL listed or CSA approved conduit connector
•
UL listed wire nuts
•
Metal vent
•
Wall or roof cap
Parts supplied
•
Vent cover
Check local codes. Check existing electrical supply. See
"Electrical Requirements."
All electrical connections should be made by a licensed, qualified
electrical installer.
Proper installation is your responsibility.
Make sure you have
everything needed for correct installation. It is the responsibility
of the installer to comply with the installation clearances
specified in these instructions.
IMPORTANT: Observe all governing codes and ordinances.
When installing cooktop, use at least minimum dimensions given.
•
To reduce the risk of burns or fire by reaching over heated
surface units, cabinet storage space located above the
surface units should be avoided. If cabinet storage is to be
provided, the risk can be reduced further by installing a range
hood that projects horizontally a minimum of 5" (12.8 cm)
beyond the bottom of the cabinets.
•
The cooktop must be a specified cooktop that is approved to
be installed within a countertop.
Check the cooktop burner
box for an approved installation label. If you do not find this
label, contact your dealer to confirm that your cooktop is
approved.
•
Use the countertop
opening dimensions that are given with
these Installation Instructions. Given dimensions are
minimum clearances and provide 0" (0 cm) clearance.
•
The cooktop should be installed away from strong draft
areas, such as windows, doors or fans and strong heating
vents or fans. The cooktop should be located for convenient
use in the kitchen.
•
The venting system for a downdraft
cooktop must terminate
outdoors.
•
A downdraft
cooktop is not approved for use in mobile
homes.
•
Grounded electrical supply is required. See "Electrical
Requirements"
section.
Product Dimensions
B
A
C
D
E
A. 21%6" (54.1 cm)
B. 303/_ " (77.1 cm) on 30" (76.2 cm) models; 36%" (92.3 cm)
on 36" (91.4 cm) models
C. 27_" (73 ram) depth of bumer box
D. 15%" (39.6 cm) depth of blower housing
E. 3_/2ft (t06. 7 era) long power supply cable (factory installed)
Clearance
Dimensions
...................
A
F
B
C
_-..
A. 30" (76.2 cm) min. on 30" (76.2 cm) models; 36"
(91.4 cm) rain. on 36" (91.4 cm) models
B. 1" (25.4 ram) minimum distance to nearest combustible
surface extending
18" (45. 7 cm) above cooktop
C. 29V_" (74.9 cm) on 30" (76.2 cm) models; 36_/2" (90.2 cm)
on 36"(91.4
cm) models
D. 2t" (53.3 cm)
E. 1" (2.5 cm) minimum
clearance between back wall and
cutout
F For minimum
clearance to top of cooktop, see NOTE*
*NOTE: Minimum clearance is 24" (61 cm) when bottom of wood
or metal cabinet is protected by not less that 1/4"(6.4 ram) flame
retardant millboard covered with not less than No. 28 MSG
sheet steel, 0.015" (0.4 mm) stainless steel, 0.024" (0.6 ram)
aluminum or 0.020" (0.5 ram) copper.
2
Advertisement
