1. Manuals
  2. Brands
  3. STEELE PRODUCTS Manuals
  4. Lawn Mower
  5. SP-PM135G
  6. Owner's manual

STEELE PRODUCTS SP-PM135G Owner's Manual

21" gas powered lawn mower
Hide thumbs Also See for SP-PM135G:
Table of Contents

Advertisement

Quick Links

Download this manual See also: Owner's Manual
Owner's Manual
//
awlli
5P-PHI35fi
tons_vlcE CALL:
888-8S5-5881
PARA 5ERVICIO LLAME:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SP-PM135G and is the answer not in the manual?

Questions and answers

Related Manuals for STEELE PRODUCTS SP-PM135G

Summary of Contents for STEELE PRODUCTS SP-PM135G

  • Page 1 Owner's Manual awlli tons_vlcE CALL: 888-8S5-5881 5P-PHI35fi PARA 5ERVICIO LLAME:...

  • Page 2: General Operation

    Introduction Do not tamper with the engine controls or alter the gove- rnor speed; doing so may create an unsafe condition This rotary-blade, walk-behind lawn mower is intended to resulting in personal injury. be used by residential homeowners or professional, hired Safety operators.

  • Page 3: General Service

    • Never store the machine or fuel container where there is o Do not operate machine while under the of aUcohomor an open flame, spark, or pilot light such as on a water , Never operate mower in wet grass. Always be sure of heater or on other appliances.

  • Page 4: Product Specification

    1. Remove the handle knobs from the mower housing Product specification impoAant: Route the cables to the outside specification Component the handle as you install the handle. Rated power 3600w/5HP Rated sPeed ............... Displacement t40cc Cutting width 1.5" to 3" (3 Positions) Wheels 7"and12"...

  • Page 5: Product Overview

    Product Overview Impo_ant:To reduce starting problems, add fuel stabiiizer to the fuel all season, mixing it with gasoline less than 30 days old. Figure 5 Checking the Engine Oil Level Figure 4 Service lnter,_ah Before each use or daily 1. Air filter 1.

  • Page 6: Stopping The Engine

    Adjusting the Cutting Height Adjusting the cutting height may bring you into contact with the moving blade, causing sedous injury. ° Stop the engine and wait for all moving pads to stop. * Do not put your fingers under the housing when adjusting the cutting height.

  • Page 7: Mulching The Clippings

    Operating Tips Mulching the Clippings Your mower comes from the factow ready to mulch the grass and leaf clippings back into the lawn.if the grass General Mowing Tips bag is on the mower, remove it (refer to Removing , Clear the area of sticks, stones, wire, branches, Grass Bag) before mulching the clippings.
  • Page 8 Cutting Leaves • After cutting the lawn, ensure that half of the lawn shows through the cut leaf cover. You may need to make more than one pass over the leaves. • if there are more than 5 inches (13 cm) of leaves on the lawn, set the front cutting height one or two notches higher than the rear cutting height.

  • Page 9: Replacing The Air Filter

    3. Tip the mower onto its side, with the dipstick down, Replacing the Air Filter to drain the used oil out through the oil fill tube (Figure 15). Service interval:Every 25 hours 1. Use a screw driver to open the air filter cover (Figure 12).

  • Page 10: Cleaning The Mower

    2.Whennomoreclippings comeout,stopthewater 5. Installthe newblade(turnthe bladeboltclockwise) andmovethe mowerto a dry area. andall mountinghardware (Figure16). 3. Runthe enginefor a few minutesto dry the housing to preventit fromrusting. Storethe mowerin a cool,clean,dry place. Preparing the Mower for Storage Gasoline vapors can expJode. o Do not store gasoJine more than 30 days.

  • Page 11: Removing The Mower From Storage

    1, Handle knob 2, Move the handle forward as shown in Figure Removing the Mower from Storage Connect the wire to the spark ptug. Figure Figure...

Table of Contents