How To Install The Seat; How To Assemble The Steering Wheel; How To Assemble The Gauge Wheels - YARD KING 42566x89 Instruction Book

ASSEMBLY
HOW TO INSTALL THE SEAT
Use the fasteners shown below to install the seat. The fasteners are
shown at fug size.
3.
Check the operating position of the seat. If the seat needs to
be adjusted, loosen the two wing bolts. Slide the seat forward
or backward along the seat adjusting holes as shown. Tighten
the wing bolts (A).
1.
2
(A)
94160
(B)
710257
Carefully remove the plastic beg from the seat.
Align the holes in the seat hinge to the holes in the seat
(Figure 1). Fasten the seat to the seat hinge with the fasteners
as shown.
Seat
Seat Hinge
Seat
Adjusting Hole
A
ure t
HOW TO ASSEMBLE THE STEERING WHEEL
Fasteners are not required to assemble the steering wheel. Attach
the steering wheekas follows:
1. Make sure the front wheels point forward.
2. Look at the hub of the steering wheel. Make sure the locking
clip is in place inside the hub.
3. Slide the cover over the steering post (Figure 2)
4. Slide the steering wheel onto the steering post. Push on the
steering wheal. The steering wheel will lock onto the steering
post. Pull on the steering wheel Make sure the steering wheel
is locked in place.
5 Some models have an optional decal in the parts bag Attach
the decal to the center of the steering wheel as shown.
Steeling Wheel
Steering Post
Hub
Cover
(Optional)
HOW TO ASSEMBLE THE GAUGE WHEELS
Use the fasteners shown below to install the gauge wheels. The
fasteners are shown at full size.
1 Attach the gauge wheels to the axle bolts with the fasteners.
Locking
Ring
Axle Bolt
Was her_
Gauge Wheel
Figure 3
NOTE: The axle bolt is mounted in the LOW position. To change
the position to a higher cutting position, see "How To Adjust
The Gauge Wheels" in the Maintenance section.
7 t 0846 10