Changing The Filter; Led Lighting; Replacing Led Lights - Kenmore 253.4474 Use & Care Manual

Changing the Filter LED Lighting
AIR FILTER
The air filter is located inside one of the 2 Liter Door Bins.
The air filter cover is located on the upper right side of the
control box. In general, you should change the air filter
every six months to ensure optimal filtering of refrigerator
odors. The electronic control is equipped with a Change
Filter Indicator to remind you to change your fiJten To reset
the "Change Filter Indicator Light" hold the air filter button
until the light changes.
To Install Or Replace The Air Filter
° Pull down on the front of the air filter cover to release
the hinged bottom cover.
° Allow bottom cover to swing open and then remove
the old filter and discard it.
° Unpackage the new filter and place it inside the
hinged bottom cover of the housing.
° Push the hinged bottom cover upward until the tab
snaps into closed position.
Replacing LED Lights (select models)
To Replace LED Lights:
1. Unplug your refrigerator's power cord.
2. Remove light cover by pushing up and out.
3. Hold the LED cover with one hand and pull the
connector with the other hand while pressing the
connector latch.
4. Replace LED light and snap in place assuring the
light is facing in toward the unit (inside fresh food).
LED Light Removal LED Light Harness Removal
NOTE
LED lights are in series so if one is bad or unplugged,
several lights may not light up.
Open Air Filter Cover
Air Filter
Remove Air Filter
15