Euro-Pro Shark Roadster EP732 Owner's Manual page 6

Crevice TooJ and Dustin9 Brush
! Crevice Tool with Brush
For radiators_ crevces, +%_!: -" ....
corners, baseboards and
between cushions
2. . Ister'4 Brush
The dusting brush is used
for the furniture
i
our Vacuum
Note: Once all attachments are in
place unwind a sufficient length
of cable and insed the plug into
the wall outlet+ A yellow mark on
the power cord shows the ideal
cable length. Don't pull the power
cord beyond the red mark.
I. Insert the power plug into the wall
2. Press the Power On/Off button
located on the unit to turn the
vacuum cleaner "On'.
3_
lo rewind the power cord press the
cord rewind button with your foot
and hold the plug of the power cosd
with your hand to ensure that it
does not whip causing damage or
Oleanin_ the Hand Held Air Driven
Turbo Brush
T_rbine
1 Slide locking latct_ forward then tilt the
top housing of the brush upwards. The
top housing is hinged and will tilt up
approximately 45 ° only
2. Inspect turbine wheel and air passage
for debris andlor blockage. Remove
debris if present
3 Inspect the rotat ng brush for built-up
hair or stdng If present, remove by
carefully cutting with scissors. Avod
damaging or cutting bristles.
4 Once clean, close the top cover of the
turbo brush and slide the locking latch
toward the rear of the brush to lock.
Important: This vacuum cleaner is
equipped with a motor protective
thermostat If for some reason yoz
vacuum overheats the thermostat will
automatically turn the unit off. Should ths
occur, unplug the vacuum from the wal!
outlet and turn off the switch. Empty the
dust cup, "TapClean" the dust cup filter
and check for blockages in hose and
suction inlet. Allow the unit to cool for a
minimum of 45 minimum prior to
resta_ing the unit. To restart, re-plug the
vacuum into the wan socket and turn the
switch back on