Basic Operation; Turning The Power On And Off; Selecting A Weighing Unit - A&D FG-60KAL Instruction Manual

5-1. Turning the power ON and OFF

1. Press the ON/OFF switch to turn the power ON.
All the display symbols are displayed and the scale waits for the weighing data to
become stable.
(Only the units available illuminate.)
After the weighing value internally becomes stable, the display turns off for a
moment and zero is shown with the ZERO indicator (power-on zero).
If the weighing value is unstable, the display shows "------". Check if anything
touches the weighing pan, or check if there is strong wind or vibration.
The range for power-on zero is within ±10% of the weighing capacity (kg) around
the calibrated zero point.
If the power is switched ON while there is a load beyond this range, the scale shows
"------". Remove the load on the weighing pan.
2. Pressing the ON/OFF switch again, and the power will be switched OFF.
? Auto power-off function
It is possible to have the power automatically switched OFF, if zero is displayed for
approximately 5 minutes. See "9-2. Function list" and set the function "F1-1" or "F1-
2" .

5-2. Selecting a weighing unit

Press the MODE switch to select a weighing unit.
? "lb" and "oz" will be available for U.S.A. models only.
? For U.S.A. models, it is possible to specify the display unit "lb", "oz" or "kg" that will
shown first when the power is switched on. See "Function list F3".

5-3. Basic operation

1. Turn the display on via the ON/OFF switch.
2. Select a weighing unit using the MODE switch.
3. When the display doesn't show zero, press the
set the display to zero.
4. When using a tare (container), place the container on the weighing pan, and press
the RE-ZERO ( TARE ) switch to set the display to zero.
5. Place the object to be weighed on the pan or in the container, and wait for the
STABLE indicator to be displayed and read the value.
5. BASIC OPERATION
lb oz kg pcs
RE-ZERO ( ZERO ) switch to
8