Troubleshooting - VTech Go! Go! Smart Wheels Ambulance User Manual

4. For added fun, the ambulance interacts with
other VTech Go! Go! Smart Wheels
®
playsets. Simply roll the ambulance over one of
the playset's SmartPoint™ locations to see the
ambulance's light flash and to hear greetings,
fun sounds, short tunes and sing-along songs
(each playset sold separately).
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct heat source.
3. Remove the batteries when the unit is not in use for an extended period of time.
4. Do not drop the unit on hard surfaces and do not expose the unit to moisture
or water.

TROUBLESHOOTING

If for some reason the program/activity stops working or malfunctions, please
follow these steps:
1. Please turn the unit OFF.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
Turn the unit ON. The unit should now be ready to play again.
4.
5. If the product still does not work, replace with a new set of batteries.
If the problem persists, please call our Consumer Services Department at 1-800-
521-2010 in the U.S. or 1-877-352-8697 in Canada, and a service representative
will be happy to help you.
For information on this product's warranty, please call VTech
the U.S. or 1-877-352-8697 in Canada.
IMPORTANT NOTE:
Creating and developing Infant Learning products is accompanied by a
responsibility that we at VTech ® take very seriously. We make every effort to
ensure the accuracy of the information, which forms the value of our products.
However, errors sometimes can occur. It is important for you to know that we
stand behind our products and encourage you to call our Consumer Services
Department at 1-800-521-2010 in the U.S. or 1-877-352-8697 in Canada, with
any problems and/or suggestions that you might have. A service representative
will be happy to help you.
TM
® 1-800-521-2010 in
3
Note:
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION
IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE
MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST
ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT
MAY CAUSE UNDESIRED OPERATION.
THIS CLASS B DIGITAL APPARATUS COMPLIES WITH CANADIAN ICES-003.
CET APPAREIL NUMÉRIQUE DE LA CLASSE B EST CONFORME À LA NORME
NMB-003 DU CANADA.
Caution: changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
91-002543-009
4