Table of Contents
Advertisement
Before You Call • Solutions
to common
problems
Problem
Solution
Oven smokes excessively
when broiling.
•
Incorrect
setting.
Follow broiling
instructions
in Setting Oven Controls
section.
•
Be sure oven door is opened to broil stop position
when broiling.
• Meat too close to the broil element.
Reposition
the broil rack to provide
proper
clearance
between
the meat & the element.
Preheat the broil
element
for searing.
• Meat
not properly
prepared.
Remove excess fat from meat. Cut remaining
fatty
edges to prevent
curling,
but do not cut into lean.
• Grease
has built up on oven surfaces.
Regular cleaning
is necessary
when
broiling
frequently.
Old grease
or food
spatters cause excessive
smoking.
Flames inside oven or smoking from oven
•
Excessive spillovers
in oven. For example
this will happen for pie
vent.
spillovers
or large amounts of grease left on the oven bottom.
Wipe
up
excessive
spillovers
before
starting
oven.
If flames
or excessive smoke
are present follow
broiling
instructions
in Setting Oven Controls
section.
[]
Oven control
panel
beeps & displays
• Oven control
has detected
a fault or error condition.
Press sToP key pad to
any F code error,
clear the error code. Try Bake or Broil function.
If the F code error repeats,
remove
power from appliance,
wait 5 minutes and then repower
appliance
and set clock with the correct
time of day. Try Bake or Broil function
again.
If the fault
recurs, press sToP to clear and call 1-800-4-MY-HOME®
for
assistance
(See back cover).
Select Clean does not work.
• Oven control
not set properly.
Review instructions
in Select Clean section.
Soil not completely
removed
after
• Select Clean was interrupted.
Review instructions
in Select Clean section.
Select Clean.
•
Excessive spillovers
on oven bottom.
Remove before starting
Select Clean.
•
Failure to clean soil from the oven frame,
the door liner outside the oven
door gasket and the small area at the front center of the oven bottom.
These areas are not in the self-cleaning
area, but get hot enough to burn
on residue.
Clean these areas before the self-cleaning
cycle is started.
Burned-on
residue can be cleaned
with a stiff nylon brush and water
or a
nylon scrubber.
Be careful
not to damage
the oven gasket.
Oven racks discolored.
Convection
fan does not rotate.
• Oven racks left in oven cavity
during
Select Clean. Always
remove oven
racks from oven cavity
before
starting
a self-clean
cycle.
Clean by using a
mild, abrasive
cleaner
following
manufacturer's
instructions.
Rinse with clean
water, dry and replace
in oven.
• Oven door is open. Convection
fan will turn off if oven door is opened
when
Convection
is active.
Close oven door.
29
Advertisement
Table of Contents
