Advertisement
Available languages
Available languages
Problem
Possible
Cause
Corrective
Action
Grill will not light
Burner flame is
yellow and gas
odor can be
,
2.
smelled
3.
Excessive
flare-up
Burner blows out
1. The ignition wire came off
the electrical
igniter.
2. The distance
between the
ignition pin and the burneris
greater than 0.1-0.2 inch.
3. The ignition wire is broken.
4. The battery has died.
5. The battery is in the wrong
polarity.
6. The electrode
tip does not
produce
sparks at the
burner port.
7. No gas supplied.
8. Air shutter opening is too
big.
The air shutter opening
is
not properly
set.
Spiders or insects block the
air shutter.
Gas leaks
1. Grilling fatty meats while
knobs on "HIGH".
2. Spray water on gas flames.
3. Hood closed when grilling.
1. LP tank is empty.
2. Burner is not aligned with
the control valve.
3. Gas supply is not sufficient.
1. Reconnect
the ignition wire to the
electrical
igniter.
2. Loosen the ignition pin and adjust the
distance,
then fasten it again.
3. Call customer
service for are
placement
ignition wire.
4. Install a new AA battery.
5. Change the battery polarity.
6. Reinstall
the electrode.
7. Turn on the regulator
valve.
8. Loosen the air shutter and adjust the
opening to a smaller size.
1. Loosen the air shutter and adjust
theopening
to have blue flames.
1/4 in. opening for LPG.
1/8 in. or less opening for NG.
2. Clean blockages.
3. Check for the source of gas leaks.
1. Grill fatty meats when the grids are
cold while the knobs are on the
"LOW" setting. Move the meats to the
warming
rack if flare up continues
until flame settles down.
2. Never spray water on gas flames.
3. Hood up when grilling.
1. Refill the LP Tank.
2. Install the burner correctly.
3. Check the gas supply hose and make
sure there are no leaks and no knots.
26
Advertisement
