Advertisement
Fabric Softener
Dispenser
Pour liquid fabric softener
and water into fabric softener
dispenser
Cleaning Fabric
Softener Dispenser
Separate for cleaning
This dispenser automatically
releases liquid fabric softener at the
proper time during the cycle. To
use, follow these steps:
1 Make sure dispenser is securely
attached to agitator.
2 Pour liquid fabric softener
into dispenser, using amount
recommended on package.
3 Add water to dispenser until it
reaches the maximum fill line.
1 Remove the dispenser from the
top of the agitator.
2 Separate the dispenser cup from
the cover by grasping the top and
pushing down on the inside of the
cup with your fingers. Dispenser
cup will pop free from the cover.
3 To clean dispenser, soak both the
dispenser cup and the dispenser
cover in a solution of warm water
and liquid detergent.
NOTE:
• Do not stop the washer during
the first spin. This will cause
the dispenser to empty too soon.
• Do not use the Fabric Softener
Dispenser with the Auto Soak.
• Never pour fabric softener directly
on clothes. It will leave spots on
clothes.
• Only use dispenser for liquid fabric
softeners. If dispenser gets
clogged, see Cleaning section
below.
Do not pour anything into the
agitator if the top is removed
4 If necessary, loosen build-up with
a clean, soft cloth after soaking.
Do not use a stiff brush; you may
roughen the surface of the
dispenser.
5 Rinse and reassemble dispenser.
Place dispenser back on the
agitator.
7
Advertisement
