Samsung SRD-852D User Manual page 13

MONITOR
Available after switching to Monitor mode by pressing the [MONITOR] button on the remote control.
Selects the screen status automatically.
Selects the screen mode.
Turns the monitor power on/off.
NUMBER [0~9]
Changes the system ID.
Adjusts the audio volume.
Displays the Setup Menu.
Up/Down/Left/Right(▲▼◄ ►)/ENTER
Moves the cursor up/down/left/right, and runs the
Select Menu.
Screen Freeze.
UNDER SCAN
Displays the video screen within a screen.
Using the Numeric buttons
CHANNEL 1–9
Changing the Remote Control ID
1. Press the ID button of the remote control and check the ID displayed on the DVR screen.
The factory default ID of the remote control is 00.
2. Enter 2 digits of your selection in order, while pressing the system [ID] button.
3. When ID input is done, press the system [ID] button again to check the setting.
M 
If you want to change the remote control ID to 08: Press 0 and 8 in order while the system [ID] button is pressed.
Remote control's ID and DVR's ID should be matched for proper operation. Refer to "Remote Devices". (Page 48)
AUTO
P.MODE
POWER
+/–
MENU
FREEZE
Press any button among 1 to 9.
ID RESET
Initializes the ID value to 00.
MONITOR
Activates the monitor function.
ID
Sets the ID.
Select 2 digits from 0 ~ 9 while pressing the ID Key.
MUTE
Mutes the audio out.
SOURCE
Selects the input signal source.
PIP
Selects or deselects the PIP function.
English _13