GE JVM1660 Owner's Manual page 45

Befi)re You Call For Service
Problem
Possible Cause What to Do
Oven will not A fuse in your home
start may be blown or the
circuit breaker tripped.
Power surge.
• Replace fllse or reset circuit breaker
Unplug- tim microwave oven then Dluo
o .... _ f o
it back in.
Plug not fully inserted Make sure the 3-prorlg plug on tile
into wall outlet, oven is hdly inserted into wall omlet.
"PLEASE INSERT Probe has been • Insert the probe properly into the
PROBE" appears forgotten or not oven wall outlet.
on display inserted properly.
"SENSOR ERROR"
•
appears on display
When using a Sensor
feature, the door was
opened before steam
could be detected.
Steam was not detected
in maximum amount of
time.
Floor of the oven is
warm, even when
the oven has not
been used
The cooktop light is
located below the oven
floor. When the light
is on. the heat it
produces may make the
oven floor get warm.
I)o not open door until steam is
sensed and time is shown counting
down on d splax,
Use Time Cook to heat tk)r more time.
• Tiffs is normal.
"BAD PROBE"
The probe has not been • h>ert the probe properly into tlm
appears on display completely inserted into oven wall outlet.
the oven wall outlet.
The probe is defective. • Replace the probe.
"LOCKED" appears The control has been • Press and lurid CI J_AR/( )FF ti)r
on display locked, al)out 3 seconds to unlock the control.
Food amount too Sensor Reheat is for • Else Time Cook tor large amounts
large for Sensor single servings of of ti)o(t.
Reheat recommended foods.
45