JVC MP-XP5220KR Service Manual page 5

1.1.5 Removing the parts on the mother board
(See Figure 12 ~ 15)
• Prior to performing the following procedure, remove the moth-
er board.
*Removing the fan assembly
(1) Remove the four screws I attaching the fan assembly.
(2) Disconnect the connector wire from the connector CN13 on
the mother board.
*Removing the hard disc drive
(1) Remove one screw J at the side of the mother board where
the hard disc drive is not attached.
(2) Remove the hard disc drive by moving the hard disc drive
in the direction indicated by the arrow.
*Removing the PCMCIA slot
(1) Remove one screw K (long) and the two screws L (short)
at the side of the mother board where the PCMCIA slot is
not attached.
(2) Hold and lift the connector side of the PCMCIA slot, and re-
move the PCMCIA slot.
*Removing the modem pack
(1) Remove one screw M attaching the modem pack.
(2) Pull out the socket wire connected to the modem pack.
(3) Lift the modem pack, and remove it.
Hard disc drive
L
K
Socket wire
Fan assembly
CN13
PCMCIA slot
Fig.12
Modem pack
Fig.13
PCMCIA slot
I
J
M
MP-XP7220KR,MP-XP5220KR
Fig.14
Modem pack
Socket
Fig.15
(No.G1004)1-5