Hot Water Connection - Bosch SHU 9950 Installation Instructions Manual

HOT WATER CONNECTION

THESE INSTALLATION
INSTRUCTIONS ARE
INTENDED FOR USE BY
QUALIFIED INSTALLERS
Connecting the Hot Water
Supply Line
• If using a solder joint instead of a com-
pression fitting, be sure to make all
solder connections before connecting
the water line to the dishwasher .
• Make sure there are no sharp bends or
kinks in the water line which might
restrict water flow.
• When connecting threaded pipe use pipe
thread compound or Teflon tape to seal
the connection.
• Before connecting the copper hot water
supply line to the dishwasher, it should
be flushed with hot water to clear any
foreign material.
• Apply Teflon tape or other pipe sealant
to 90° elbow fitting and connect
directly to water inlet valve*.
• Turn on the water supply to check for
leaks after making connections.
Openings for water lines must be
installed in the marked areas as shown
in Figures 8 and 9 to avoid
interference with the dishwasher
frame or other components.
10 - ENGLISH
* Water inlet valve located at the bottom
Figure 16
www.boschappliances.com
Shut off valve
(not included)
Figure 15
CAUTION
DO NOT SOLDER WITHIN 6 INCHES
(152.4 MM) OF THE DISHWASHER'S
INLET VALVE.
TEMPERATURES REQUIRED FOR
SOLDERING WILL DAMAGE THE
VALVE!
left front of the dishwasher.