GE JGP628 Installation Instructions Manual page 14

Installation Instructions
MAKING THE LP CONVERSION
(CONT.)
I-_ CHANGE COOKTOP BURNER
ORIFICES
[]
[]
Remove the top
grates, burner caps,
and burner heads.
Remove the spark
igniters from the
burner base (if
required to access
the orifices). Using a
No. 15 "Torx" head
driver bit, remove the
screws holding the
burner base in
position.
Using a 7mm nut
driver, remove the
top burner orifices.
These may be
accessed through the
hole in the cooktop.
Remove
This
Orifice Spud Located
Through This Opening
Burner cap
Burner @
head_
er
Spark igniter base
18,000 BTU Burner
(on some models)
Burner
cap
_._Burner
head
Burner _-------J
base
Spark igniter
I-_ CHANGE COOKTOP BURNER
ORIFICES (CONT.)
NOTE: On most burners,
the orifices have a spring-
Retainer
loaded retaining ring Ring
around the hex head to
hold the orifice in the nut
driver during installation
and removal. A slight amount of force is
required to push the nut driver down over
the ring.
14