DICE MediaBridge MB-1000 Installation Manual page 2

USB memory operation
Icon Legend
press button press & hold
press button
repeatedly button
• Select PRESET/DISC 1, then use the seek/track/tune buttons
to change from song to song.
• Select PRESET/DISC 2-6 to access Folders and use the
seek/track/tune buttons to navigate through the folders on your
USB flash drive.
• The Media Bridge unit will recognize the first 8 levels of
folders, with up to 200 accessible folders within each folder.
Only the first 1000 files will be read in each folder, the rest will
be ignored.
• Songs play in order of when they were added to the flash
drive.
• Use the RANDOM and REPEAT buttons on the radio/display
15
Problem Solution
Reset the iPod. Verify proper connection to iPod/interface. Check
No audio from iPod source.
for compatibility. Older iPod models don't support USB audio.
Why does the radio display show End of a playlist or folder is reached. Please select a new
"EMPTY/STOP" and no music plays? Playlist or Folder using Preset 2/DISC 2.
Check DIP switch settings. With the ignition OFF disconnect
vehicle harness from module for a few seconds and reconnect.
Cannot select the interface.
Verify that the correct button is used to access the interface.
On some cars the AM button is used to access SAT emulation.
Reset iPod and make sure the most recent iPod firmware is
Radio/ steering wheel controls do not
installed. Check vehicle user manual on how steering wheel
operate iPod.
controls work, long presses may toggle alternate function.
Playback of content selected on the iPod before connected to
Why does category read
"PRESELCTD"? the interface continues until new content is selected.
What size of USB flash drive Large capacities are supported, however up to 4GB is
should I use?
recommanded for optimal user experience.
Firmware update
STEP 1: Disconnect the Media Bridge module from the vehicle.
STEP 2: Download and install necessary software from www.diceelectronics.com
STEP 3: Open software to follow instructions for updating Media Bridge unit.
STEP 4: Plug in Media Bridge via mini USB cable and update.
STEP 5: Disconnect and reinstall the unit into the vehicle.
Mini USB port for software update
10
USB iPod operation (SAT & CDC/MP3/MD emulation)
USB iPod mode
• Use PRESET 1-6 (DISC 1-6) to enter specific modes (SONG,
change songs
PLAYLIST, ARTIST, ALBUM, PODCAST and AUDIO BOOK).
PRESET/DISC1 SEEK•TRACK
• Within each mode, use the seek/track/tune buttons to browse the
change folder
items available
PRESET/DISC2
SEEK•TRACK
• Use RND/RPT buttons in CDC/MP3/MD modes and SCAN followed
change folder
by TRACK +/- and SCAN again to set random and repeat.
PRESET/DISC3 SEEK•TRACK
Note: if the iPod is unlocked for direct control, radio control will be
change folder
limited to Songs, Playlists, and Albums. Text display will also be
PRESET/DISC4 SEEK•TRACK
limited to show only current song information.
change folder
TIP: In CDC/MP3/MD emulation, selecting DISCS is done by using
PRESET/DISC5 SEEK•TRACK
the DISC +/- buttons.
change folder
PRESET/DISC6 SEEK•TRACK
14
Troubleshooting
Problem
Text is not displaying in selected
emulation.
iPod does not charge.
Music is distorted or sound level
is too low with iPod connected.
Why is the interface not controlling
the iPod/USB drive?
Sirius tuner can't be selected.
16
Disclaimer and warranty
Important disclaimer, please read!
Unauthorized reproduction or reverse engineering is strictly prohibited! Intellectual property included is distributed
under specific license agreement with respective owners and is licensed only, not sold. No warranty, explicit or
implied, is stated. Neither DICE Electronics, LLC., nor any of its agents, distributors, dealers or vendors shall be
liable for damages.
IN NO EVENT SHALL DICE ELECTRONICS' LIABILITY EXCEED THE PRICE PAID FOR THE PRODUCT
FROM DIRECT, INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES RESULTING FROM
THE USE OF THE PRODUCT, ITS ACCOMPANYING SOFTWARE OR ITS DOCUMENTATION.
Warranty and Support
Products carry a 90 day limited warranty that protects you from defects in material and workmanship of products
sold by DICE Electronics, or its authorized agents, distributors and dealers. The warranty period begins the day a
product is purchased by the end user. Products found to be defective during the warranty period will either be
repaired or replaced by DICE Electronics at no charge unless warranty is void. Unauthorized attempt of repair or
alteration of the product in any way immediately voids this warranty. Warranty does not extend to cosmetics or
finish. A DICE product specialist must determine that defect is present in the product and issue an RMA. Be sure
that all wiring is connected as described in the user manual and all related equipment is functioning properly.
DICE Electronics disclaims any liability for other incurred damages resulting from product defects. Any expenses
in the removal and reinstallation of products are not covered by this warranty.
If experience any problems or need help, please contact your local dealer or call 888-342-3999, or visit our
support site at http://www.diceelectronics.com/support.
11
USB iPod mode
change songs
PRESET/DISC1 SEEK•TRACK
change playlist
PRESET/DISC2
SEEK•TRACK
change artist
PRESET/DISC3 SEEK•TRACK
change album
PRESET/DISC4 SEEK•TRACK
change podcast
PRESET/DISC5 SEEK•TRACK
change audio book
PRESET/DISC6 SEEK•TRACK
Solution
Identify your audio system (refer to Installation tip section) first and set
switches accordingly. Note that your vehicle may support more than
one mode. Use the TEXT button on radio/display to toggle text fields.
Check all connections. See if iPod charges while connected to
computer or wall charger. You may need to reset the iPod.
Make sure all EQ and BASS boost options are turned off on your iPod.
Please make sure that the USB connection is not loose. Make sure
that an iPod case is not preventing the dock connector from being fully
seated. Disconnect and reconnect the device. If iPod is not responding
please try resetting it. USB device must also be FAT16/32 format and
contain supported MP3, WMA or AAC content.
Unit must be in SAT emulation. Check for proper connection to the
mini DIN 8 receptacle.
17
AUX operation
• An auxiliary audio device can be connected to the Media Bridge
unit through the 1/8" mini-jack
• Audio device must be controlled manually.
• Audio level can be adjusted while in auxiliary mode by selecting
PRESET 1-4 (DISC 1-4) and using seek/track/tune buttons to
increase or decrease levels.
TIP: In CDC/MP3/MD emulation, selecting DISCS is done by using
the DISC +/- buttons.
1/8" mini stereo jack (not included)
13
Sirius Connect operation (on Satellite radio)
TM
• Stations can be saved to PRESET 1-6 by holding the desired PRESET button, while listening to the
station.
• TEXT button will toggle between the text fields.
Sirius mode in SAT radio
PRESET 1-6 PRESET 1-6 store current station to PRESET 1-6
recall PRESET 1-6 stations to store
station
Common Control
change channel
SEEK•TRACK SCAN scan channels FOLDER/CAT/TYPE change satellite category
• If a Sirius Connect compatible tuner is not detected, then either a "No Tuner" vehicle message is
displayed, or the SIRIUS option will not be selectable. Please refer to the factory manual of your radio
system about operating the Satellite mode.
• Go to Channel 000 to view the Sirius Tuner ID for activation. The 12 digit ID is displayed in two halves as
SID "123456-" followed by "-789ABC".
Installation notes:
Installed by:
Installed date:
Other notes:
12
AUX mode
change volume setting
PRESET/DISC1
SEEK•TRACK
change bass setting
PRESET/DISC2
SEEK•TRACK
change mid EQ setting
PRESET/DISC3 SEEK•TRACK
change treble EQ setting
PRESET/DISC4 SEEK•TRACK
18
Illustration: